How To Hang A Mirror On A Wall With Wire

Measure the width of your mirror and mark a point in the middle of that line.

How to hang a mirror on a wall with wire.

Take a small piece of wood approximately 12 inches 30 cm long and mark its center. Center it under the top of the mirror and hold it up tight under the wire until the wire is taut. Mark the wall near the center of the top edge with a pencil or painter s tape. Cut a piece of picture hanging wire with wire clippers that is twice that.

D rings and picture wire the mirror must have a frame around it to hang a mirror this way. Measure the width of the mirror and add 6 inches. Wrap a length of scrap wire tightly around the hanging wire several times and crimping it closed with pliers securing it to one of the screw eyes. For a large mirror start around 12 inches a standard ruler and adjust from there.

Place a scrap piece of wood that is approximately half as long as the mirror is wide underneath the hanging wire on back of the frame. Repeat for both spots where the wire connects with a d ring. Hold the mirror against the wall at the desired position. Then transfer that measurement to your markings on the wall so you know where to put the hanger.

Mark the location of the top edge and the center of the frame. Set the mirror down. You don t want them too close together. Take the wire in your picture and hold it taut from the center to measure the distance from the top of wire to the frame.

Use a tape measure to measure the distance from the top of the mirror to the top of the piece of wood. This requires attaching d rings to the back perimeter of the mirror frame wrapping wire around the d ring and then attaching one or two hooks to the wall and hanging the mirror by the wire. Use pieces of scrap wire to reinforce the hanging wire. Determine the middle of the line you have made.

Place the level against the wall at the place you want to hang the mirror and make a line on the wall with a pencil all along the top of where the mirror top will be. Hang a mirror using hooks step 1 hold the mirror in place close to eye level. Cut four medium length lengths of wire.