Installing Bevel Lap Siding

Installation of bevel siding.

Installing bevel lap siding.

Do not nail through overlaps. Wrap the house with a polyethylene or similar moisture barrier stapled to the wooden wall sheathing with a. Clear bevel cedar pre stained bleaching oil tx stk bevel cedar pre stained mahogany flame pa both faces are saw textured resulting in a perfect surface to soak in your stain or prime finish. The average exposure distance is usually determined by the distance from the underside of the window sill to the top of the drip cap see figure a.

The recommended exposure distances exposure distance is the amount of siding left exposed to the weather are 4 inches for 6 inch siding 8 inches for 10 inch siding and so on as shown in figure 3. Horizontal siding installation siding should be nailed into studs at maximum 24 in centers when applied over wood based solid sheathing and 16 in. How to install cedar bevel siding 1. For horizontal applications start with the bottom course and work up with the channels pointing upwards.

Lap clapboard or beveled siding should lap no less than 1 inch and preferably 2 inches. Bevel siding should be face nailed to studs with 1 1 4 inch penetration into solid wood using one nail per piece spaced at a maximum of 24 inches on center. Most lap siding is beveled meaning that the bottom edge is thicker than the top. Take care not to nail through the overlap of two pieces.

At the bottom install a starter strip supplied by the manufacturer or install a 1 2. Cypress is a superior exterior siding material that offers natural beauty with a rich grain texture and color that complements any architectural style. At an outside corner use a 1 3 and a 1 4 or a 1 2 and a 1 3. Place nail just above the overlap.

The side with the narrower piece will look nearly as wide as the other because of the thickness of the other piece install all trim pieces around windows and doors. Allow a 1 8 inch expansion gap between pieces if the siding is air or kiln dried. For siding up to 6 inches wide use one nail one inch up from the lap. Bevel lap siding should be installed with the lower thicker bevel butt edge overlapping the thin edge which results in an attractive shadow line.

Do not reduce the siding overlap recommendations given in the installation sections of this publication. Fasten a cedar starter strip. Always follow the manufacturer s directions. Install corner trim on all corners typically 1 by 4 inch boards nailed vertically with the wide face of a board.

Lap siding can be installed horizontally or vertically. On center when bevel sidings 11 16 or thinner are applied without sheathing.