States a hazard that may cause serious injury or death if precautions are not followed.
How to install panel door on sub zero fridge.
How to mount or remove panels from designer series doors and drawers.
Engage the tabbed bracket to the handle side of the door then slide the hinge side mounting bracket onto positioning screws.
Designer custom door or drawer panel installation.
To install the custom door panel partially insert a screw in the center of each mounting position on the hinge side of the door.
Grasp the trim on one side of the door near the bottom and pull the trim away from the refrigerator.
Overlay panels must be a minimum of 5 8 thick to support mounting the handle.
3 position the edge of the.
9 if there is flex in the center of the panel install short pieces of leftover cleat stock to the back of the panel to maintain spacing from the unit door.
If panel is less than 1 4 6 mm thick install chipboard filler panels behind panel.
10 reinstall panel assemblies and replace door trim.
Refer to the product installation guide for further installation information.
Signals a situation.
Slotted holes on the mounting bracket should slide under screw heads to support the panel.
Framed handle is loose.
Signals a situation where minor injury or product damage may occur if you do not follow instructions.
States a hazard that may cause serious injury or death if precautions are not followed.
Panel mounting brackets for designer units.
Slide door panel into door trim frame see figure 2.
Install custom panels on a designer formerly integrated product.
To install the handle reverse the above steps.
See also sub zero standard and accessory handle information.
Assembly from door see figure 2.
Refer to the sub zero design guide for design specifications.
Make sure the built in unit is secured in place with anti tip brackets to prevent tipover when panel weight is added to open doors.
With panel in position secure handle assembly to door by reinstalling handle mounting screws see figure 2.
Sub zero stainless steel door handles are typically mounted 1 1 2 from the handle side of the door or top of the drawer.
See also framed door panel installation instructions.