How To Install Metal Roofing On A Steep Roof

Align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof line.

How to install metal roofing on a steep roof.

Preparing for a safe job on a steep metal roof requires an assessment of the roof before the job begins. Be sure the larger edge is laid so that the small edge of the next panel will overlap it. Try to space the screws about 12 inches apart down the entire piece of metal. Install the roofing screws vertically along each rib in the panel.

Some roofs are so high and so steep that even working from scaffolding can be dangerous. Use your 1 1 4. Moreover try to ensure that the screws are all aligned evenly. Take your first sheet of.

To watch the entire series from the beginning click here. A roofing harness provides the extra security you need when working on such a roof. Adhere the joint where the cut edges of the shingles meet the dome with roofing tar. And for any exposed fasteners try to avoid over tightening them.

The edging or eave flashing consists of metal strips that are used to cover the perimeter of the roof. Add the metal panels. If the plumbing vent is close to the peak of the roof lap the shingles over the peak of the roof. Adhere the shingles adjacent to the flange with roofing tar.

A careful inspection will identify potential hazards and will give. It isn t hard as long as you are careful take your time do it right and be safe.