How To Install House Door Handle

With the new dead bolt and latch bolt in place fit the handle over the door s existing holes.

How to install house door handle.

Install the latch determine whether you want to use a flat rectangular faceplate or a round drive in faceplate. Remove all screws from the lever or doorknob on the inside. Begin by removing the screws from the door knob on the interior side of your door. How to install a door lock door knob deadbolt.

Gatehouse door handle assembly and installation. Repeat this process to attach the other faceplate. Use the allen key provided in the door handle kit to lock and secure the faceplate. Step 4 install the new handle and latch.

Install the inside. Remove the two screws from the latch plate on the edge of the door and remove the latch from the opening. Slide the adapter plate into the same hole in the rear of the door and screw these units in place. Slide the faceplate over the door handle and snap it into place.

Then insert the interior door handle and connect it to the latch. There may be only one mounting screw at the base of the plate. Now secure the latch to the hole by inserting the screws on the screw holes and tightening them. Remove the screws from the face plate behind the handle on the exterior side of the door using a screwdriver or drill driver.

Start by inserting the new latch into the latch hole. Replace the existing strike and latch plates in the door jamb with the new ones provided with your set. In some cases door latch plate mortises might need to be cut or enlarged. Step 3 install the exterior handle photo by ryan benyi.

Most door handles have a standard backset of 60 mm or 70 mm so you shouldn t have any trouble finding a new door handle that fits in the existing holes in your door. 6 install the interior. How to install a door lock door knob deadbolt. To remove the dead bolt and latch bolt unscrew their faceplates located on the door s inner edge.

When the latch is in place insert the external door handle into position. Insert the handleset trim into the middle hole on the front of your door. For example if your old door handle had rectangular cover plates it s probably best to stick to a new handle with similar rectangular cover plates rather than switching to. In this kit the hole for the allen key is at the bottom of the faceplate.