Install the new lock according to the manufacturer s instructions.
How to install a garage door side lock.
Can be connected to a standard locking handle.
3 hold the slide lock up.
Remove the pin that secures the inside lock handle to the lock shaft in the center of the door panel.
Once installed turn the handle 90 degrees to lock the slide lock.
It has pre drilled holes for installation.
Place a nail over the pin and tap the nail with a hammer until you expose part of the pin.
Attach the bolt and pin with screws.
Designed for flush interior installation on garage doors.
Made of galvanized steel for reliability.
These open screw holes will hold the slide lock in place.
Release the tension on side mounted extension springs by lifting the door and locking it in place on each side with a pair of locking pliers.
Spray lubricant into the openings and seams on each of the latch mechanisms at the outer sides of the door.
Locate the screw holes on the garage door s second section directly to the left of the track s rectangular slot.
This will turn the operating lever and extend the bolt into the locked position.
You ll need a helping hand on the other side of the door to help run the lock through to the other side.
The overbuilt reversible garage door side lock is designed to mount flush on the interior of the garage door and be connected to a standard locking handle.
Grab the pin with a pair of pliers to remove the pin from the shaft.
Fit the provided extension tube onto the nozzle on a can of spray lubricant.