How To Hang Letters On Wall Straight

Then i eyeballed the blue tape where i wanted to be in the frame.

How to hang letters on wall straight.

Loop the end of the rope and tie to slide onto the head of the screw. Position the letter layer on the board. For a frame with two brackets on the back place a piece of painters tape across the back. Use a level to make sure your tape is perfectly straight.

Here s how you hang letters on a wall in one easy step with just one piece of tape. Hold your letter up against the wall and adjust it until you think. Simply hang your art on the nail get it in position on the wall and tap the nail to mark the spot. For heavier letters grab double sided mounting tape.

Hold your straight edge against the wall at the level that you want the bottom of your. You can also make a diy approximation by driving a nail through the bottom of a paint stir stick. Take your marked tape and place it on the wall where you want your pictures to hang. Stick painters tape to the back of a long straight edge make sure it is very light weight.

Mark the spot where you want to hang the letter. Attach two small screws to the back of the letter. Cut paper strips the width of the side margins and apply them to the board with glue stick. Use painters tape to mark center.

We re here to show how to hang wall letters with adhesive hardware and non marking hanging strips. Using a tape measure find the center of the area that you want to hang your letters. Most of our customers prefer hanging wood letters with hanging strips or double sided mounting tape. Alternately a d ring can be used by attaching to the back of the letter with included hardware and tying the rope through the ring.

Hanging wood letters on the wall. Mark on the tape exactly where the nails or screws need to go. Choose an adhesive based on the size and weight of the letters. Trim the letter layer close to the lettering at the top and along each side.

Securely personalize walls with custom letters created just for you. Stick a piece of tape across the letters. Lay the letters out on the floor. Then use a screwdriver to make a hole where you want the nails to go.

You can see the full instructions here.