How To Hang A Puzzle On Wall

Press the puzzle down onto the foam board then scrape off any excess glue that was squeezed out from between the two objects.

How to hang a puzzle on wall.

The puzzle should still be together if you flipped it quickly and smoothly. Wherever a stud lines up with your puzzle gently remove just that border piece. Take your board over to your wall and hold it up exactly where it is going to go. Hammer a nail into the wall where you want to hang your puzzle.

Glue the puzzle to the backing material. My kids gave me a sweet star wars jigsaw puzzle for christmas and after it was done we thought it d be nicer to hang it on a wall rather than just put it aw. A little bit of the puzzle paper will be left on the tape but that ok. There is typically a brush attached to the bottle cap and you will use that to spread the glue along the edges of the puzzle.

How to glue and mount a puzzle for display step 1. Hanging the puzzle was simple i simply used 4 sets of command picture hanging strips. Use the wire to hang the puzzle on the wall. Place a piece of poster board or cardboard on each side of your puzzle a piece in front of and a piece behind.

Start with a completed jigsaw puzzle on a flat surface. You can also use binder clips on all sides to secure closed once you do this flip the puzzle over and remove the back piece of poster board. Apply glue to the surface of the foam board or cardboard you cut earlier. The easiest way to glue your puzzle is to actually pour the glue right on top of the puzzle and then use a piece of cardboard or a business card to spread the glue around.

Twist the ends of the wire to make hooks. Once you have all four or six pieces out hold the puzzle back on the center mark. Carefully transfer your glued puzzle over the foam board aligning it with the edges. Pour a light amount of puzzle glue across the short end of the puzzle covering about a 6 inches.

You now have a hanger on the back of your puzzle. Pull and tear off two or three pieces of wax.