Drill the hole at least 1 4 inch deeper than the length of the lower portion and vacuum or blow out the hole.
How to flatten concrete wall.
Spread a thin coating of mortar to the underside of tiles before setting them in place on the.
Roll liquid concrete bonding agent over the surface of the wall in fairly straight lines using a short napped.
We have an old victorian house with a concrete floor throughout the ground floor.
Drop in the anchor and hammer on the pin to expand the bottom of the shield against the wall of the hole.
A hammer drive anchor requires only a small pilot hole.
Step 3 mix the plaster mix your plaster according to the manufacturer s instructions preferably in an area away from drying winds and direct sun.
The bull float is a flat long handled tool used to flatten minor ridges and holes as well as embed aggregate particles further into the concrete bringing the smoother cream consistency concrete to the surface for better finishing.
From the front of the house to the doors the floor slopes up around 7cm but is not too uneven across the width so we re going to put down a thick underlay and carpet.
The bull float should have rounded ends not flat or straight ends.
Sand any particularly bad areas of concrete with rough grit sandpaper.
Immediately level and prepare further using a bull float.
For a flat finish apply a layer of dash that is almost liquid in consistency.
The ground floor is partitioned in two by a dividing wall and french doors.
Spread the mortar with a notched trowel allowing the notches to lightly scrape the concrete below.
The one shown requires only a 1 4 inch hole.
How to smooth a concrete wall finish step 1.
Apply a coat of the mixture to your concrete wall before plastering it and allow it to dry for a day.