How To Fix Stripped Screws In Door Hinge

Fix it the right way not the wrong way.

How to fix stripped screws in door hinge.

Open the door wide and insert a wedge under the bottom outside corner to level it. How to tighten stripped hinge screws. To remove the loose wood screw drill out the stripped hole and glue in a dowel the same diameter as your drill bit. Maybe the kids swung on a gate and pulled the hinge screws out or a cupboard door was swung too wide and the screws pulled right out.

Step 3 remove the stripped screw. We ve all had the problem of a screw getting pulled right out of a hole and stripping out the wood that should be holding it. How to fix a stripped screw hole. Then you ll need to fix the stripped area.

Easy fixes may also be ineffective in situations where a heavy door has caused hinge screws to strip out the wood on the edge of the door or the door frame. Then glue and cut the dowel so it s flush with the edge of the door or hinge. Take your screwdriver and remove the others screws that hold the hinge onto the door. To relocate the hinge remove the screws from the hinge and slide it up or down a few inches.

If the screw of the hinge is the part that is stripped you will need to get a stripped screw remover from a hardware store. In these situations the best repair method is to drill out the screw hole with a 1 2 inch bit then fill the enlarged hole with a glued 1 2 inch hardwood plug or solid hardwood dowel. I have a very heavy 1930 s bathroom door that i have tried all the tricks to fix and it keeps pulling the screws out of the top hinge. Remove the screws that hold the loose hinge leaf to the door jamb.

My last ditch effort is to try this fix with the dowels. Then bore out the stripped holes. This will wedge into the head of the screw and pull it. On my cabinets the door actually fell off because a chunk of particle board fell off.

This last time it even pulled out the screws from the bottom hinge at the frame. You can then drive the screw into the dowel to secure it. Due to the design of the doors a prefab door would stick out like a sore thumb. If the hinge and jamb are painted cut the paint around the leaf with a utility knife swing the leaf away from the jamb.