How To Fix Old Garage Door Spring

Step 1 unplug the garage door opener and clamp the door to the track.

How to fix old garage door spring.

Adjust the springs on both sides of the door the same way. Retest the door balance as you did in step 1. Use locking pliers or a c clamp to secure the door to the track to keep it from opening when you release the tension on the springs 1 x research sourcestep 2 loosen the set screws while holding each spring with a winding bar. Snap a locking pliers onto the torsion tube to lock it into place while you tighten the drums.

Leave the locking pliers in place and repeat the tightening procedure on the other side. This video will show you how to repair a mis aligned garage door cable. Put on eye. Rotate the drum to wind the cable into the winding grooves.

This system is unsafe and sh. If your garage door cable is at an angle or l. Open the door to relieve the spring tension and secure it open with c clamps in the tracks. Install the new spring reinstall the pulley and reconnect the safety cable and you re done.

Test the spring by lifting the door about 3 feet. Once the spring is free of tension remove from its track hanger. The general process is simple and safe. If it was opening too quickly move it to the next lower hole.

Lubricate the spring with garage door lubricant then remove the clamp from the garage door. Position a sturdy ladder to the side of the springs rather than working directly in front of them for safety reasons. Diy garage door repair and save money. If the door was closing too quickly move the spring to the next higher hole on the bracket.

If the door remains in place the replacement was a. Disconnect the spring from the track bracket and the spring pulley and disconnect the safety cable from one end.