How To Fix Manual Garage Door Lock

Step 3 loosen the screws that secure the locking bar guides at each end of the door panel with a 3 8 inch socket wrench.

How to fix manual garage door lock.

Once installed turn the handle 90 degrees to lock the slide lock. Close the garage door and secure the door down with a pair of vice grips. To lock the slide lock from the outside you need to install a lock handle with the spindle inserted into the square hole next to the operating lever. So the garage tilt a door lock has been ripped out.

Garage doors won t open refuse to lock or age and warp. So the door will need to be opened and a new lock fitted to g. If you didn t drill the holes in the right space you will have to loosen one of the nuts to give the bolt a bit of play. The second set of nuts can then be hand tightened to hold the lock onto the rail.

Pull the handle away from the face of the door and spray a generous amount of lubricant on the inner. Close the garage door and attempt to lock the door from the inside. The locking bar is keeping the door locked. This will turn the operating lever and extend the bolt into the locked position.

Locate where the ends of the locking bars hit the track and miss the hole. The power goes out. Loosen the machine screws on the handle base plate using the appropriate screwdriver. Put the bolt ends through the holes in the garage door rail.

Place the vice grips on the door track above any door roller and lock the vice grips on the track.