Slide the new panel into position and line up the track rollers and hinges with the predrilled holes in the panel.
How to fix garage door panel.
This will make sure that the door does not spring open when you are working on it.
Your garage panels are attached to each other and the track rollers.
Removing the old panels.
Hammer out the bend.
There are several ways you can fix the bend in the garage door panel.
To adjust the switch there is usually a screw on the motor unit that when turned will increase or decrease how far the door descends when closing.
One of the most simple fixes you can do is hammering out the bend in the door.
How to fix a bent garage door panel.
Once this is done close the garage door holding it all the way down.
If it s a simple dent then this shouldn t be too hard to do.
Lift the panel you re replacing out of the door.
Garage door seal is loose or broken.
Unscrew the damaged panels to remove.