How To Fit A New Door Handle

New doorknob or handle.

How to fit a new door handle.

First you need to remove the screws holding the existing knob or handle in place. Before you learn how to change door locks measure the space where you ll install the replacement. Marking the door handle positions. Fitting new door handles is a great example.

Before you can fit a door handle to a new door you will first need to mark regions to be drilled and cut. Take care to measure carefully as matching the size can be especially problematic in older homes. How to fit door handles and latch to interior doors. First of all decide on an appropriate height for the door handles and mark the centre of the door handle on the edge of the door with a pencil.

Drill the screws carefully being sure to keep your drill level with the floor. Press in the metal piece in the slot and the doorknob should come loose. Follow our handy guide to fitting interior door handles. These will be either on the cover plate or if not look for a small slot on the side of the handle.

Be careful to fit the latch into the chiselled area and screw into the pilot holes that were made earlier. Using the screws that came with your door handle kit attach the faceplate to the door. Remove the old door handle or knob. From this post you will learn how to fit the latch latch plate and door handles to a new door and door frame.

Measure the diameter of the holes currently cut out of your door so you can select a new door lock that fits those dimensions. If your new door handle attaches to the door at a point below the lower borehole like ours you may need to drill another hole to accommodate. This post is going to show you how to fit a door handle in 6 simple steps. Line up the spindle on the back of the handle with the slot in the latch sliding any mechanisms up or down as needed to fit the handle onto the door.