To get started hammer a center punch into a point just above the keyhole and take it out.
How to drill out a door handle lock.
There is no point in drilling a lock that has anti drill pins.
Keyed entry knobs also called privacy knobs usually have a turning lock on one side of the door and a keyhole on the other side.
Certain locks are not going to open as easily as others even with drilling.
Close the door and look for where the lock bolt or latch bolt contacts the doorjamb.
Door lock openings hold deadbolt locks inside a door.
If you can t drill to install a lock consider simply removing and replacing the door knob.
It features two bi metal hole saws and a height alignment window for accuracy.
Use to install door locks on wood and metal doors.
Drill out the lock cylinder.
Aim the drill into the area just above the keyway.
2 bi metal hole saws.
No special tools required just a drill and small bit.
Using the screws that came with your door handle kit attach the faceplate to the door.
Here is how to drill out your garage door lock in under a minute and open your door.
Then using an 1 8 inch drill bit slowly drill through the point you made with the center punch.
The dewalt door lock installation kit helps you install door locks on wood and metal doors.
Backsets and 1 3 8 in.
How to drill door lock openings.
Keyed entry door knob.
Be careful to fit the latch into the chiselled area and screw into the pilot holes that were made earlier.
The goal is to drill through the pin tumblers not the keyway itself.
Wood doors can.
Lock openings also support the latch of the lock mechanism as it moves in and out of the door.
Before you attempt to drill a lock keep in mind that you won t be able to drill locks that have a center pin made of steel or a ball bearing in the middle pin.
Understand the lock well enough to drill it properly.
Once you ve drilled through and broken the pins you may need to insert a flat screwdriver to retract the latch and open the door.
These type of pins are made out of hardened steel so that they are harder than the drill bit.
Use a sharp drill bit that is designed for metal drilling.
Drill the screws carefully being sure to keep your drill level with the floor.
Use a combination square to transfer this center mark across the face of the jamb that is onto the flat strip between the inside edge of the jamb and the.